COM-кабель для калибровки бесперебойников APC Smart-UPS

2018-01-26 14:27:01 apctest 3.14.14 (31 May 2016) redhat
Checking configuration ...
sharenet.type = Network & ShareUPS Disabled
cable.type = USB Cable
mode.type = USB UPS Driver
Setting up the port ...
Doing prep_device() ...

You are using a USB cable type, so I'm entering USB test mode
Hello, this is the apcupsd Cable Test program.
This part of apctest is for testing USB UPSes.

Getting UPS capabilities...SUCCESS

Please select the function you want to perform.

1)  Test kill UPS power
2)  Perform self-test
3)  Read last self-test result
4)  View/Change battery date
5)  View manufacturing date
6)  View/Change alarm behavior
7)  View/Change sensitivity
8)  View/Change low transfer voltage
9)  View/Change high transfer voltage
10) Perform battery calibration
11) Test alarm
12) View/Change self-test interval
 Q) Quit

Select function number: 10

This test instructs the UPS to perform a battery calibration
operation and reports the result when the process completes.
The battery level must be at 100% and the load must be at least
10% to begin this test.

Battery level is 100% -- OK
Load level is 25% -- OK
Clearing previous self test result...CLEARED

The battery calibration should automatically end
when the battery level drops below about 25%.
This process can take minutes or hours, depending on
the size of your UPS and the load attached.

Initiating battery calibration...INITIATED

Waiting for calibration to complete...
To abort the calibration, press ENTER.

Battery level: 100%............................................................................................................................................
Battery level: 97%...............
Battery level: 90%.....................
Battery level: 83%..................
Battery level: 76%.................
Battery level: 70%.............................
Battery level: 64%................
Battery level: 57%.............
Battery level: 51%............
Battery level: 46%..........
Battery level: 41%........
Battery level: 36%............
Battery level: 32%.........
Battery level: 28%........
CALIBRATION COMPLETED
Result of last self test: PASSED

1)  Test kill UPS power
2)  Perform self-test
3)  Read last self-test result
4)  View/Change battery date
5)  View manufacturing date
6)  View/Change alarm behavior
7)  View/Change sensitivity
8)  View/Change low transfer voltage
9)  View/Change high transfer voltage
10) Perform battery calibration
11) Test alarm
12) View/Change self-test interval
 Q) Quit

Select function number: q

2018-01-26 15:24:57 End apctest.